Briquetting press Falach 35

Briketovací lis Falach 35FALACH 35 is briquetting press which is already equipped with automatic shut-off. It will be a very good assistant with low failure rate and high resistance. If you do not know what to do with sawdust or shavings, here you have the ideal solution.These types of presses have increased volumes of the oil tanks instead of the hydraulic oil cooler

Technical data of briquetting press FALACH 35 


The table below will provide informations about important technical parameters of briquetting press FALACH 35 


  Type identification  FALACH 35
  Dimensions – lenght - width - height  186 - 89 - 110  cm
  Briquette diameter 50  mm
  Press capacity 25 - 40 kg/hour
  Weight of press 400 kg
  Hopper volume 0,33 m3
  Pump motor input 4 kw
  Power consumption 2,2 kw/hour
  Oil cooler no
  Operation continuous
  Automatic switching-ou yes
  Specific weight of briquettes 900 kg/m3
  Maximum noise level 68 dB

The equivalent level of acoustic pressure at the operator´s post does not exceed 70,0 dB ( 68 dB ).  

Warranty and post-warranty service of briquetting presses FALACH


FALACH company provides 12 months guarantee on all kinds of briquetting presses FALACH and further agrees to hold customer service 10 years after the warranty period.


Important information when operating briquetting machine



  1. Prohibition of connecting devices to the divorce, which does not match valid regulations (allowed variation of the nominal amount of power supply voltage is 10%).
  2. Do not exceed the setting of maximum pressure of 14 MPa.
  3. Any repair, modification, maintenance and cleaning work is to be carried out when the machine is turned off, disconnected from the power source.
  4. Do not expose the press to excessively moist environment and protected it against weather conditions.
  5. When the machine is operating avoid direct contact with moving parts of the press (mainly the front clamp and press die, then the feeding wheel inside the hopper).
  6. It is prohibited to extinguish press, when energized, with water or foam fire extinguisher, because there is a risk of electric shock (recommended extinguishing powder, snow or halon). 



We confirm that this briquetting press FALACH 35 satisfies the conditions of the following specifications and standards:


ČSN EN ISO 12100-1, ČSN EN ISO 12100-2, ČSN EN 60204-1, ČSN EN 61000-6-4, ČSN EN 55011, ČSN EN 982, ČSN EN 954-1, ČSN EN ISO 14121-1.


Contact form